- Full complement cylindrical roller bearings
- Slewing bearings
- Cylindrical roller bearings
- Taper roller bearings
- Deep-groove ball bearings
- Angular contact ball bearings
- Thrust ball bearings
- Track roller bearings
- Unidirectional rotation bearings
- Spherical thrust roller bearing
- Spherical Roller Bearing
- Cylindrical roller thrust bearings
- Tunnel boring machine
- Ship deck crane
- Railway Crane
- Tower crane
- Mobile crane
- Vehicles/trailers
- Excavator
- Antennae and Telescopes
- Articulated buses
- Man lifts
- Open-pit mining equipment
- Offshore technology
- Solar energy plants
- Steel mills
- Wind energy turbines
- Mechanical engineering
- Harbour and shipyard cranes
- Rudder propellers
- Tandem bearing used on screw shaft of parallel twin screw extruders
- Bearings for metallurgical equipment bearings
- Copper pipe rolling mill bearings
- Helix welding rolling mill bearing
- Construct machine bearings
- Slewing bearings for stacker and reclaimer machines
- Cement mechanical bearings
- Spin and weave machine bearings
- Arrester of whirlpool compressor bearing
- Derrick mechanical bearings
- Electric power equipment bearings
- Other application field bearings
Cylindrical roller thrust bearings
The Cylindrical roller thrust bearings and the needle roller thrust bearings are applied to take axial loads. They have a high load capacity.The seat ring and the shaft ring of them are made of bearing steel. The cage material can be copper base alloy, aluminum alloy, steel or plastic.The Cylindrical roller thrust bearings made in LYXS use copper base alloy as the basic cage material. Aluminum alloy, carbon steel and plastic are also available on the request of the clients. In that case, some special suffix should be appended to the bearing codes to show the difference. LYXS provides the thrust needle roller-cage assemblages of RTL brand. The cage of the assemblages can be pressed from low carbon steel plate or plastic injection molding or made by steel-chopping machine.The clients can order for whole sets of bearings or order for the seat rings, shaft rings, or cylindrical roller-cage (needle roller-cage) assemblages alone.When mounting, any deviation between the shaft and the axial line of the bore should be avoided. If possible, the surface of the bearing washer should be fully supported. The block shoulder should have enough rigidity and be straightly vertical to the rotating axial line. In order to avoid elastic deformation, the height of the shaft shoulder should at least reach the center of the inner-row rollers in the seat ring, or reach the center of the outer-row rollers along the shaft ring.The minimum loads offered should be 0.2% of the basic dynamic load ratings.